Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - monuplamoodu@yahoo.com

Pages: [1]
1
Input files and parameters / SLURM Script help...???
« on: September 08, 2020, 06:30:25 PM »
Hi Everyone

I am new to RASPA and recently we have installed the same at our internal cluster and I am trying to run a test calculation with the following SLURM script but I keep getting an error that is "Permission Denied". The below script is basically from the RASPA manual but I was wondering what's wrong with this script. It would be highly appreciated if someone can help me out here!
Thanks in advance...

#!/bin/bash
#SBATCH -J Name
#SBATCH -p highmem
#SBATCH --nodes=1
#SBATCH --ntasks-per-node=1
#SBATCH --cpus-per-task=1
#SBATCH --export=ALL

module load RASPA2/May-2020

valhost=$SLURM_JOB_NODELIST
export RASPA_DIR=${HOME}/RASPA/
$RASPA_DIR/monu.input


-Monu

Monu Joy
Graduate Student & Teaching Assistant
Functional Materials Design & X-ray Diffraction Lab (Office: CAMP 328)
Department of Chemistry & Biomolecular Science, Box 5814
Clarkson University, Potsdam, NY 13699, USA

E-mail: joym@clarkson.edu | Mob: +1 (315) 323-4313

Pages: [1]