Topics

Hi,

I'm seeking advice.

I'm attempting to plot the DensityProfile.vtk file that I obtained from my simulation run. However, I'm encountering an issue where the plot appears completely white without any visible content.
All the data inside the file consists of very small values.

-----------------------------------------------------------
Part of my file:

# vtk DataFile Version 1.0
CELL_PARAMETERS 19.152000 19.152000 19.152000 90.000000 90.000000 90.000000
ASCII
DATASET STRUCTURED_POINTS
DIMENSIONS 150 150 150
ORIGIN 0.000000 0.000000 0.000000
SPACING 0.127680 0.127680 0.127680
POINT_DATA 3375000
SCALARS scalars double
LOOKUP_TABLE default
0
0.000584217
0.00084387
0.00183199
0.00266144
0.00421935
0.00569792
0.00809249
0.00786169
0.0121387

-----------------------------------------------------------
Thank you

Hello everyone,
I hope you are all doing well,

I am currently working on a project related to gas separation by adsorption on MOFs using GCMC on RASPA on an HPC. I made a run of 120,000 cycles thinking that they will be enough to equilibrate, yet I found that couple of 10,000 cycles are additionally needed. After my first run was completed, I wanted to continue running the job for the additional cycles instead of repeating the entire run from the beginning. I tried the option of ContinueAfterCrash, and RestartFile but neither worked and showed the same previous output file. Are there any other possible ways to reconvene the run from where it stopped without the need to repeat it?

Your guidance is appreciated and many thanks in advance.